What angle and width should my bindings be?
Hey,
I have a 140 lib tech board. I am 170 cm or 5 foot 6. I am a pretty intermediate rider i ride the whole mountain and can do basic rails and aerial tricks etc. My bindings are pretty basic, Dura-Tech i think the brand is. I really just want a basic set up that most riders of my abillity would use. I know it varies but what would a standard set up be? What width should my bindings be? Also what angles should they be at?
Any advice would be very helpful 
Thanks
Also I am about 50 kg – 110 lbs.
I just want a rough idea of a good binding width and angles.
Thanks
For the width your reference point should be that the inside of your bindings should match up with the outside of your shoulders. i find that to be the most comfortable stance. it makes it easier to turn and easier to land off of boxes and jumps. for angles, mine are 15 and -9. however, i do a lot of switch riding. for your riding style i would say put it at about 15 on the front and -3 on the back. so both bindings are pointing a bit more towards the end they are on. for example, your front binding should be pointed towards the nose and back binding slightly towards the tail.
|
|
Simpson Dura-Tech 9464 SDT-E 6″ 15 Degree Elbow $49.99 |
|
|
9 lot 3″ dura vent stainless tee connector pro tech special gas vent fasnseal $35.00 |
|
|
Simpson Dura-Tech 9666 SDT-E 8″ 30 Degree Elbow $69.99 |
|
|
Simpson Dura-Tech 9446 Attic Insulation Shield NEW $44.99 |
|
|
Simpson Dura-Tech 9248AN SDP-SB 11″ Support Box/Trim $14.99 |
|
|
GAS WATER HEATER DURA VENT KIT 4″ STANDARD MOUNT STAINLESS PRO TECH FAS N SEAL $250.00 |
|
|
Simpson Dura-Vent Dura Tech Chimney Pipe 8″ x 48″ $199.99 |
|
|
Simpson Dura-Vent Dura Tech Chimney Pipe 8″ x 48″ $179.99 |
Tags: bicycle, bike, dura tech chimney, dura tech saddle pad, dura technologies, duratech, duratech industries, flash, flex, tech